Hollywood-racks HR575 Prorider User Manual download pdf (Page 2)

Assembly Instructions:

For ease of assembly, we suggest

that you use your vehicle’s hitch.

1. Install your insert tube H

into the hitch. Unlock hitch pin

J and insert it through hole in

the hitch and the rack. Then

tighten the lever H7 on the front of the

insert tube so the insert tube will not

move during assembly.

2. See Fig. 2 and 3: Gently insert

Main Beam E into Insert tube H,

aligning holes H3 with E2. The main

beam can rest on pin H5. There are

two plastic washers (E3) attached to

main beam E, please take care not to

accidentally knock them off during

assembly. Insert bolt A2 with washer

through holes, then place washer on

end of the bolt and hand tighten nut.

3. Insert pin H6 through holes H4 and

E4.Then install R clip A4 through the

pin. The main beam will now be in a

fixed Horizontal position. Tighten Bolt

A2 and nut securely with wrenches.

4. After tightening, remove R clip A4 &

Pin H6 and rotate Main Beam E into a

folded (vertical) position. Insert pin H6

through holes H2 and E1 to check

alignment. Main beam should be able

to rotate easily, but not be too loose.

5. Remove pin H6 and rotate main

beam back to it’s horizontal position to

continue assembly.

Fig. 1

Fig. 2

Fig. 3

FIG. 4

6. See Fig. 4: Assemble the side beams G

to the main beam E using the top plate F and

hardware A1. Tighten nuts securely.

1 2 3 4

Hollywood Pro 1

Comments to this Manuals

No comments