Hollywood-racks HR1450 SportRider SE User Manual download pdf (Page 3)

Step 2: Install Wheel Holders:

Rotate and remove L pins from holes

A. Rotate wheel tubes to a horizontal

position, then replace L pins into holes

B as indicated.

Slide wheel Holders E and F onto

wheel tubes as indicated.

Position the long frame hook on top of the round vertical post facing

the vehicle. Squeeze the lever and the tab together, so that the lever

is all the way up (engaged). Now wiggle the plastic housing down

onto the tube aligning the index guides with the index slots. You may

have to gently tap it with your other hand. Remember the lever

must be engaged to install it onto the tube. Repeat for the short

hook facing in the opposite direction.

Using the clamps:

After the clamp is installed, it can only be raised by engaging the

lever. The clamp can physically be pushed down without engaging

the lever but it is highly recommended that the lever also be

engaged when lowering the clamp.

Fig. 2a

Fig. 2b

Fig. 3a

Fig. 3b

Fig. 3c

Fig. 3d

Step 3: Installation and operation of Clamp System

Fig. 2c

After installing wheel holders, install

the “stop” screws (item P) into the

bottom of the wheel tubes as indicated

in Figure 2c. Use Phillips screwdriver.

Item P

1 2 3 4 5 6

No comments

Hollywood-racks HR1450 SportRider SE User Manual Page 3